Our Products

Waterproofing Chemicals

Hydro Epoxy

High Resistance, Epoxy Bonding Agent

scroll down

Hydro Epoxy is a thixotropic, epoxy paste system, that complies with the performance requirements for structural bonding.

  Download PDF

Areas of Application

For Structural Bonding Between Pre-fabricated Concrete Structures and Reinforced or Pre-stressed Concrete Elements

For Structural Bonding of Steel Plates and Pultruded Composite Plates to Reinforced and Pre-stressed Concrete

For Waterproofing inside the Watertanks Where Hydrostatic / Negative Preassure Exists

Features & Benefits


Excellent Adhesion to Concrete, Steel and Composite Materials

Organic Mineral Adhesive for the Structural Bonding of Concrete, Steel and Composite Material Elements

Resistant to Environmental Chemical Aggression and Suitable for all Exposure.

Safeguards the Health of Operators

Method of Application

Structural bonding of prefabricated concrete structures to reinforced and prestressed concrete elements, and of steel slabs , pultruded plates and composite fabrics to reinforced and prestressed concrete elements Surface filling of cracks prior to injection of fluid mortars for structural consolidation

Surface penetration is most important step before application to get best results and avoid failure

The surface must be free from any loose materials, crumbling powdery encrusted walls, fungus, moss, oil, grease and mould release agents

Clean the surface using scrappers and wire brushes

Then clean the walls with high pressure water, wait for 2 days for the surface to dry

The walls must be dry before the application

Use of acidic and alkaline chemicals, detergents, cationic surfactants should be avoided

It is advisable to wait for 28 days for curing the fresh masonary / new concrete

Technical Information

Appearance Part A grey paste / Part B beige paste
Volumetric mass Part A 1650 kg/m3- Part B 1720 kg/m3
Mixing ratio Part A :Part B = 1 : 1
Viscosity of the mixture 1000000 mPa's(rotor 95 RPM 2.5)
Density of the mixture Brookfield method
1700 kg/m3
Pot life(1 kg):
At +50C ≥100 min
At + 230C ≥ 20 min
At +300C ≥15 min
Temperature for application +5 0C to +300C

Other Information


Use at temperatures between +5°C and +30°C Apply on dry substrates Do not apply to dirty or flaking surfaces Protect surrounding surfaces from accidental smearing and staining, which would be difficult to remove clean tools immediately after use with solvents (ethyl alcohol, toluene, xylene)


21.7 kg/M (per mm of thickness)


Part A 5 Kg Bucket & part B 5 Kg Bucket


12 months in the original packaging Protect from frost, avoid direct exposure to sunlight and sources of heat


Always use protective gloves and eyewear both during mixing and during application avoid any contact with the skin. Use in a well-ventilated environment

Quick Inquiry

Please enter name ! Please enter valid name !
Please enter 10 digits mobile no. ! Please enter valid mobile no. !
Please enter email id ! Please enter valid email id !