Dubond’s Dupoxy Prime SFW is a two component epoxy based primer with good penetrating properties for concrete surfaces.
About Us
DUBOND Group is to become a truly global Indian Company. We share the common dream of all Indians to be a truly Indian multinational. And, we look forward to achieving that goal in the next decade.
Contact Info
- C/3,1001 & 1002, Annushruti Tower,S.G. Highway, Thaltej, Ahmedabad, Gujarat, India - 380054.
- info@dubond.in
- +91 74860 13545
- +91 79268 56815
Dupoxy Prime SFW
Application
Packaging
Shelf Life
Advantage & Benefits
Technical Data
Uses
- Surface Preparation : Thorough surface preparation is vital. For best results Dubond recommends mechanic al preparation techniques. (For example, mechanical scarifying, grit-blasting, sand blasting).
For flooring and tanking works, care must be taken to ensure that the substrate does not suffer from rising dampness. If such conditions exist, consult Dubond. - New concrete floors : Should be at least 28 days old or have a moisture content of less than 5% before proceeding with epoxy application. Laitance and deposits on new concrete floors are best removed by light grit blasting, mechanical scrabbling or grinding.On smaller areas through etching using Reebaklens may be considered. After etching the dloor, it should be throughly washed with clear water and then allowed to dry.
- Old concrete floors : Again, mechanical cleaning methods are strongly recommended on old concrete floor, particularly where heavy contamination by oil and grease has occured or existing coating are present. These may well have been absorbed several millimeters deep into the concrete. To ensure good adhesion all contamination should be removed and the surface throughly cleaned of all dust and loose debris. A through detergent wash is also recommended followed by cleaning with water and mopping it off to dry state
- Mixing : Add the entire contents of the hardener tin to the base and mix throughly for 3 min. until homogeneous, using a slow speed drill (400-500 rpm) fitted with a suitable mixing paddle.
- Application : Once mixed the primer should be applied immediately in a thin continuous film to the clean prepared surface. Work the primer into the surface using a stiff brush or roller. Excess application and pudding should be avoided. On porous surfaces Dupoxy Prime SFD will be absorbed very quickly leaving characteristics coloured dry patches. It is recommended that a second priming coat be applied to these dry areas. This not only helps to ensure good adhesion but also prevents air release from the porous substrate which may cause bubbles in the final epoxy topping later.
For Dupoxy SL applications, leave the Dupoxy Prime SFD to dry overnight.
Available in 1 & 5 kg packs.
Dupoxy Prime SFD has a shelf life of 12 months when stored in unopened containers under normal warehouse conditions
- Can be applied even on damp moist surfaces.
- Improves the adhesion of epoxy floor toppings and epoxy mortars with the substrate.
| Properties | @ 20°C | @ 35°C |
| Pot life | 4 hrs. | 1.5 hrs. |
| Cure | 4 - 6 hrs. | 2 - 4 hrs. |
| Time between coats | 4 - 6 hrs | 3 - 5 hrs. |
| Initial hardness | 24 hrs. | 18 hrs. |
| Full cure | 7 days | 5 days |
| Specific gravity | 1.022 g/cc | |
It is suitable for priming concrete surfaces prior to the application of any of the Dupoxy SL,SC,TCS,TC range of resin based floor toppings, Dupoxy range of protective coatings or Dupoxy Putty for repair mortars.
Related Products
